These are navigation links to move inside this page.

 | Global Site

Global Navigation

Primary contents


Each time the scanner is connected to the PC, the Windows hardware-assistant starts and the scanner is listed in the device manager as unknown device.

No special device driver is necessary for using the scanner. The scanner uses the Twain-Interface. To avoid the hardware assistant routine onto each Windows start, click on „continue“ and „Done“ and „Do not show this message anymore“ when the hardware assistant has started. When prompted to select a designation of the driver do not select any drive. Windows will not find a driver and the scanner will be listed as unknown device in the device manager. The installation is completed with these steps and no further action is required.

Did the answer help you?
Please help us to improve our FAQ-System by clicking one of the Feedback-Buttons below.

Answer too technical
Answer too short
Answer not up to date
Related FAQs

Local Navigation

Back to top

Site Information

Imprint | Terms of use
© Copyright 2007 Konica Minolta Holdings, Inc. All rights reserved.